Extrude Along Curve
Extrude Along Curve runs a cross-section along a path curve and turns it into a mesh. Use the built-in circle, square or rectangle, or wire in your own curve as the cross-section, and shape how thick it is along the way with the Thickness ramp. Use it for pipes, ropes, cables, rails, pillars and trim bands. Pick the Ribbon profile for a flat strip that lies along the curve, facing up: paths, roads and trails. The result already has UVs that follow the path, so it is ready to texture.
Inputs
Section titled “Inputs” Curve
path The curve the shape travels along.
Curve
profile Optional A curve to use as the cross-section instead of the built-in shape.
Outputs
Section titled “Outputs” Mesh
A mesh of the cross-section swept along the path.
Parameters
Section titled “Parameters”| Parameter | What it does | Default |
|---|---|---|
Profile | The built-in cross-section to sweep. Ignored when a curve is wired into the profile input. Options: Circle, Square, Rectangle, Ribbon | Circle |
Radius | How big the circle is, from its center to its edge. Shown when Profile is Circle. | 15 cm |
Divisions | How many points go around the circle. More gives a rounder tube. Shown when Profile is Circle. | 16 |
Size | How wide the square is. Shown when Profile is Square. | 30 cm |
Width | How wide the rectangle is. Shown when Profile is Rectangle. | 30 cm |
Height | How tall the rectangle is. A wide, flat rectangle makes a band or strip. Shown when Profile is Rectangle. | 8 cm |
Width | How wide the ribbon is, across the path. Shown when Profile is Ribbon. | 100 cm |
Width divisions | How many strips the ribbon is split into across its width. More strips let it bend over bumpy ground. Shown when Profile is Ribbon. | 1 |
Profile scale | Scales a curve wired into the profile input. The built-in shapes ignore it. | 1 |
Thickness | How thick the sweep is from the start of the path to its end: 1 is full size, lower pinches it. Dip the middle for a pillar with a narrow waist. | Flat at 1 |
Path divisions | How many rings the path is cut into. More rings follow the Thickness ramp more smoothly. | 16 |
End caps | Closes the two ends of the tube with flat faces. Has no effect on a closed path, a ribbon, or an open profile. | On |
See also
Section titled “See also”- Curve: draw the path and the cross-section.
- Procedural Height Map: wind a rope or grain pattern along the tube.
- Curve nodes: the other nodes that take a curve in.