Box
Box makes a single box, and you set its width, height and depth separately: equal sides give a cube, unequal ones a plank, a slab or a crate. It is the quickest way to start a graph, or to try out what another node does. Cut it along each side with Segments X, Y and Z to give Noise and other detail nodes points to move. Wire a mesh or curve into it and it makes the box around that geometry instead. For a shape built from several solids, use Blockout instead.
A box around other geometry
Section titled “A box around other geometry”Wire a mesh or curve into the Box node’s input and it builds the smallest box that holds it, lined up with the X, Y and Z axes: a crate around a prop, a block to cut with, or a size check. Padding pushes every face out by the same amount. Width, Height, Depth and Pivot drop out of the panel while something is wired, since the input sets the size; Segments X, Y and Z still cut the box. The output is the box alone, so add a Merge if you want the input beside it. A flat input, like a Grid, still gets a box at least 1 cm thick.
Resizing in the viewport
Section titled “Resizing in the viewport”Select an unwired Box node and its outline appears in the viewport with a handle on each face. Drag a side handle to change Width or Depth: the opposite side moves with it, so the box stays centered. Drag the top handle to change Height. With Pivot on Bottom (the default) the box stands on the ground and grows upward; with Center it also gets a bottom handle and grows both ways. With grid snap on, sizes step by the grid size. The parameters update when you let go.
A Cube saved before Box replaced it opens as a Box with all three sides set to its old size, its old segment count on every side, and Pivot on Center, so it sits exactly where it did.
Inputs
Section titled “Inputs”Optional: a mesh or curve to build the box around. Leave it empty for a box sized by Width / Height / Depth.
Outputs
Section titled “Outputs”A new box mesh, around the input when one is wired (the input itself is not passed on).
Parameters
Section titled “Parameters”| Parameter | What it does | Default |
|---|---|---|
Width | How wide the box is, left to right (along X). Shown for a none input. | 50 cm |
Height | How tall the box is (along Y). Shown for a none input. | 50 cm |
Depth | How deep the box is, front to back (along Z). Shown for a none input. | 50 cm |
Segments X | How many times the box is cut across its width. More cuts give later nodes, such as Noise, points to move. | 1 |
Segments Y | How many times the box is cut across its height. | 1 |
Segments Z | How many times the box is cut across its depth. | 1 |
Pivot | Where the box sits: resting on the ground, or centered on the origin. Options: Bottom, Center Shown for a none input. | Bottom |
Padding | How much bigger than the input the box is, on every side. Shown for a wired input. | 0 cm |
See also
Section titled “See also”- Blockout: build a shape from several solids.
- Grid: a flat sheet instead of a box.
- Noise: rough up a subdivided box into a rock.
- Create nodes: the other nodes that make geometry from nothing.